Tidak ada produk di keranjang.
-33%
Programmer Modul
TOMBOL MOUSE OMRON D2FC-F-7N MICRO SWITCH SAKLAR KECIL 3 PIN D2FCF7N
**Ciri-ciri tombol mouse yang sudah aus:
– Susah klik (macet)
– Single klik jadi double klik
– Otomatis klik sendiri tanpa sebab
**Spesifikasi:
Model: D2FC-F-7N
Ukuran: 5x13mm
Rp4.000 Rp6.000
Harga satuan utk 1 pcs
Tombol Mouse yang digunakan untuk reparasi atau pengganti spare part saklar mouse gaming yang sudah aus. dan juga sangat bagus untuk mouse biasa.
**Ciri-ciri tombol mouse yang sudah aus:
– Susah klik (macet)
– Single klik jadi double klik
– Otomatis klik sendiri tanpa sebab
**Spesifikasi:
Model: D2FC-F-7N
Ukuran: 5x13mm
#omron #mouse #tombolmouse #mikroswitch #saklar #D2FCF7N
| Berat | 10 gram |
|---|
Produk Terkait
- Programmer Modul
UNO R3 SMD CH340 ATMEGA328P PLUS KABEL USB DAN PIN HEADER
Spesifikasi :
– Microcontroller : ATmega328 SMD
– Operating Voltage : 5V
– Input Voltage (recommended) : 7-12V
– Digital I/O Pins : 14 (of which 6 provide PWM output)
– Analog Input Pins : 6
– Flash Memory : 32 KB (ATmega328) of which 0.5 KB used by bootloader
– SRAM : 2 KB (ATmega328)
– EEPROM : 1 KB (ATmega328)
– Clock Speed : 16 MHzSKU: ARD02 - Programmer Modul
SOLENOID DOOR LOCK 12V DC – PENGUNCI PINTU ELEKTRIK
Parameter:
– Tegangan: 12VDC
– Arus: 0.35A
– Ukuran: L:27mm*W:29mm*H:18mm
– Latch telescopic length: 10mm
– Energized forms: intermittent;
– Unlocking time: 1S
– continuously energized 10S ;Wiring:
Kabel Merah : Positive (+12VDC)
Kabel Hijau / Hitam: Negative (0V GND)SKU: ARD56 - Programmer Modul
MICRO USB 5V 1A 18650 TP4056 LITHIUM BATTERY CHARGER MODULE CHARGING
With MICRO USB female socket can be connect with mobile phone charger directly for charging lithium battery.
Input Voltage5V, Cut-off charging voltage 4.2V +/- 1%
Maximum charging current 1000mA
Battery over-discharge protection voltage 2.5V
Battery over-discharge protection current 3ANOTE:
1. Ampere meter can only be connected to 5v input end of the module.
2. It is better that the charging current is 37% of the battery capacity. If you charge to the battery of 1000mAH, current of 400 is enough.
3. The connection wire should not be too thick.
4. Make sure the connect point is good.
5. If the input voltage is too high, like 5.2v, the current will be less than 1000mA, it is normal. It is protection function, auto-substract the charging current to avoid burn damage to chip.
6. NO Reveral polarity.SKU: ARD19
