Tidak ada produk di keranjang.
-20%
Programmer Modul
PASSIVE BUZZER MODULE FOR ARDUINO
Pin Definition
1. VCC: 3.3-5V
2. GND: Ground
3. I/O: I/O Interface of SCM
Rp12.000 Rp15.000
Description
1. No oscillation source, need square wave(frequency 2K-5K ) to drive
2. Audino 9012 drive;
3. Work Voltage: 3.3-5V
4. Set bolt hole, easy to assemble
5. PCB Dimension: 3.3cm*1.3cm
Pin Definition
1. VCC: 3.3-5V
2. GND: Ground
3. I/O: I/O Interface of SCM
| Berat | 15 g |
|---|
Produk Terkait
- Programmer Modul
W5500 ETHERNET NETWORK MODULE HARDWARE TCP / IP 51 / STM32
Description:
The W5500 module is a module based on Ethernet WIZNET new type of chip W5500, module integrates the whole hardware TCP/IP protocol stack, no need code implements the TCP/IP protocol stack, support transmission rate of 10/100MBPS, support sleep mode and wake on LAN ,Within the integrated 32K TX/RX cache,support 8 independent ports run at the same time,Module supports 3.3V or 5V power supply, convenient for the user to use in the SCM system different, module and MCU system communication mode is SPI protocol,Support SPI clock frequencies up to 80M, provide STM32 and 51 SCM client, server, three modes of UDP routines.SKU: ARD07 - Programmer Modul
UNO R3 ATMEGA328P-PU 16U2 DIP COMPATIBLE WITH ARDUINO BOARD PLUS KABEL USB.
Technical specs:
– Microcontroller : ATmega328P
– Operating Voltage : 5V
– Input Voltage (recommended) : 7-12V
– Input Voltage (limit) : 6-20V
– Digital I/O Pins : 14 (of which 6 provide PWM output)
– PWM Digital I/O Pins : 6
– Analog Input Pins : 6
– DC Current per I/O Pin : 20 mA
– DC Current for 3.3V Pin 50 mA
– Flash Memory : 32 KB (ATmega328P) of which 0.5 KB used by bootloader
– SRAM : 2 KB (ATmega328P)
– EEPROM : 1KB (ATmega328P)
– Clock Speed : 16 MHz
– Length : 68.6 mm
– Width : 53.4 mmSKU: ARD01
