Tidak ada produk di keranjang.
-6%
Cable & Connector
KABEL JUMPER DUPONT 30CM 10 BUAH MALE – MALE
Panjang kabel = 30 cm
Jenis kabel :
M-M = Male to Male
Harga diatas per 10 helai kabel
Rp8.500 Rp9.000
Kabel jumper male to male Jumper Wire Cable 1P-1P Arduino 20cm dupont
Panjang kabel = 30 cm
Jenis kabel :
M-M = Male to Male
Harga diatas per 10 helai kabel
Pakage = 10 x kabel jumper
#dupont #cable #arduino #kabel #malefemale #male #female #wire #kabelarduino #jumper
| Berat | 5 g |
|---|
Produk Terkait
- Programmer Modul
CH341A 24 25 SERIES EEPROM FLASH BIOS USB PROGRAMMER
Spesifikasi:
USB EEPROM/MCU Programmer
Support 24EEPROM and 25 SPI flash 8pin/16pin chip
Support USB to TTL with CH341A chip
Recognize 25 series chip automatically
And support download STC series procedure of singlechip
With 24/25 status indicator lamp
SPI pin to support expanding the utility
Provide 5V-3.3V power supply output
Dimension:70mm x 27mm
100% brand new and high qualityKelengkapan:
1 Unit CH341A USB DOWNLOADER for EEPROM 24/25 Series
1 pcs PCB dan header untuk SMD IC 8 dan 16 pinSKU: ARD09 - Sensor & Transducer
HC-SR501 PIR MOTION SENSOR MODULE
Description:
100% brand new T6 LED Adjustable Focus Torch
Qty: 1pcs
Product Type: HC–SR501 Body Sensor Module
Operating voltage range: DC 5-20V
Quiescent Current: 50uA
Level output: High 3.3 V /Low 0V
Trigger: L can not be repeated trigger/H can be repeated trigger (Default repeated trigger)
Delay time: 5-200S(adjustable) the range is (0.xx second to tens of second)
Block time: 2.5S(default)Can be made a range(0.xx to tens of seconds
Board Dimensions: 32mm*24mm
Angle Sensor: 100 cone angle
Operation Temp: -15-+70 degrees
Lens size sensor: Diameter:23mm(Default)
Weight: Approx 10g
Easy and Convenient to useSKU: SNSR05 - IOT & ESP8266
NODEMCU ESP8266 CP2102 WIFI IOT LUA
Secara umum :
– Based ESP8266 Serial WiFi SoC dengan onboard USB to TTL menggunakan IC CP2102 (USB to UART Bridge Virtual COM Port)
– Bisa diprogram langsung lewat USB.
– Development Board dengan Open-Source Firmware ini dapat dipergunakan untuk mendevelop aplikasi IoT hanya dengan beberapa baris Lua script.
– Wireless standard : IEEE 802.11b/g/n
– 6 x Digital I/O, 3 x PWM Channels, 1 x ADC Channel
– Full I/O control through WiFi network
– GPIO with 15mA current drive capability
– Supports Smart Link intelligent networking
– Built in 32-bit MCU
– built-in TCP/IP protocol stack, and support multiple TCP Client connection
– UART/GPIO data communication interfaceSKU: n/a
