board
Menampilkan semua 4 hasil
- Relay & Driver Motor
Modul Relay 1 Channel 12V Arduino
MODULE INTERFACE
Input part :
VCC : Connect to power positive (according to the relay voltage range)
GND : Connect to power negative
IN : Relay module trigger pin (low level trigger)Output part :
Normally Opened (NO) : Normally open pin of relay. NO pin is not connect to COM pin when relay off. NO pin is connect to COM pin when relay on
Common pin (COM) : Common pin of the relay
Normally closed (NC) : Normally close pin of relay. NC pin is connect to COM pin when relay off. NC pin is not connect to COM pin when relay onElectrical parameters :
– Voltage version : 12V
– The static current : 4mA
– Working current : 65mA
– Trigger voltage : 10-12V
– Trigger current : 2mASKU: MOT17 - Programmer Modul
UNO R3 ATMEGA328P-PU 16U2 DIP COMPATIBLE WITH ARDUINO BOARD PLUS KABEL USB.
Technical specs:
– Microcontroller : ATmega328P
– Operating Voltage : 5V
– Input Voltage (recommended) : 7-12V
– Input Voltage (limit) : 6-20V
– Digital I/O Pins : 14 (of which 6 provide PWM output)
– PWM Digital I/O Pins : 6
– Analog Input Pins : 6
– DC Current per I/O Pin : 20 mA
– DC Current for 3.3V Pin 50 mA
– Flash Memory : 32 KB (ATmega328P) of which 0.5 KB used by bootloader
– SRAM : 2 KB (ATmega328P)
– EEPROM : 1KB (ATmega328P)
– Clock Speed : 16 MHz
– Length : 68.6 mm
– Width : 53.4 mmSKU: ARD01