Tidak ada produk di keranjang.
IOT & ESP8266
Menampilkan semua 10 hasil
- IOT & ESP8266
ESP-12F (ESP-12E upgrade) ESP8266 remote serial WIFI wireless modul
Protocol 802.11 b/g/n
– Wi-Fi Direct (P2P), Soft-AP
– Integrated TR switch, Balun, LNA, Power Amplifier dan Matching Network
– Integrated TCP/IP protocol
– Integrated PLL, regulators, dan Power Management Unit
– Output power +19 dBm pada 802.11b mode
– Integrated temperature sensor
– Support antenna diversity
– Power down leakage : < 10uA
– Integrated low power 32-bit CPU, yang dapat digunakan sebagai processor aplikasi
– SDIO 2.0, SPI, UART
– STBC, 11 MIMO, 21 MIMO
– A-MPDU dan A-MSDU aggregation 0.4s interval
– Wake up dan Transmit packet dalam < 2ms
– Konsumsi daya standby < 1.0 mW (DTIM3)
– Ukuran board : 24 mm x 16 mm
– Tegangan kerja 3.3VSKU: IOT04 - IOT & ESP8266
WEMOS D1 CH340 CH340G WIFI DEVELOPMENT BOARD ESP8266 ESP-12 ESP-12E
Fitur:
Catu daya : 9V – 24V
Fitur : WiFi 802.11b/g/n | 2,4 GHz
Dimensi : 68,6 x 53,4 (mm)
Berbasis mikrokontroler/mikroprosesor : ESP-8266EX
Jumlah port i/o : 12 (11 digital & 1 analog input)
Port antarmuka : PWM, IC
Port pemrograman : Micro USBKelengkapan:
1x Board Wemos D1 R2 Wifi Uno, Arduino Compatible
1x Header 40×1SKU: IOT9 - IOT & ESP8266
NRF24L01 2.4GHZ WIRELESS TRANSCEIVER MODULE
Berikut fitur-fitur dari chip NRF24L01;
-Menggunakan frekuensi 2.4Ghz global ISM band yang bebas lisensi
-Data rate up 2MBps , modulasi GFSK efisien , kemampuan anti-gangguan , sangat cocok untuk aplikasi kontrol industri
-125 channel operation, untuk memenuhi komunikasi point to point atau multi-point
-True single chip transceiver
-Complet OSI layer in hardware, built-in hardware CRC , deteksi kesalahan FEC
-Digital interface (SPI) speed 0-8MHz
-Short switching time enable frequency hopping
-Fully RF compatible with nRF24XX
-5V tolerant signal input pads
-Tegangan kerja yang rendah 1,9 ~ 3.6V, konsumsi daya yang rendahSKU: IOT8 - IOT & ESP8266
NRF24L01 PA LNA ANTENNA 2.4GHZ LONG DISTANCE 1.1KM WIRELESS TRANCEIVER
Spesifikasi:
– Tegangan input: 1.9 3.6V DC
– Double header pin 2 x 4 pin
– Arus: Maksimal 115mA
– Bekerja pada frekuensi 2,4GHz
– Kecepatan transmisi data maksimal 2 Mbps
– PA gain: 20dB
– LNA gain: 10dB
– Multiple frequency (125 frequency)
– Dilengkapi Antena 2.4 GHz eksternal dengan jangkauan jarak 1.1 km
– Ukuran: 45.5 x 16.5mmKelengkapan:
– NRF24L01 long distance + PA + LNA
– SMA AntennaSKU: IOT07 - IOT & ESP8266
D1 MINI V1 – MINI NODEMCU 4M BYTES LUA WIFI IOT
Spesifikasi:
– 11 digital input/output pins, all pins have interrupt/pwm/I2C/one-wire supported(except D0)
– 1 analog input(3.3V max input)
– a Micro USB connection
– Compatible withArduino
– Compatible with nodemcu
– Auto Reset
– Header belum di solderKelengkapan:
1x WeMos D1 mini
2x Long female pins
2x Short female pins
2x Normal pinsSKU: IOT05 - IOT & ESP8266
ESP-01 ESP8266 SERIAL WIFI WIRELESS MODULE WIRELESS TRANSCEIVER
Upgraded Version ESP-01,all Flash are upgraded to 1M support loud service remote Upgraded Version module are fully supports the previous firmware.
The latest firmware version 1.0.1, the default baud rate of 115200, (AT + CIOBAUD = to change the baud rate), because the old version of the module is 512k bytes of storage space is not enough, so we can not upgrade the 1.0. 1 version, but also support the cloud services!Specifications:
– 802.11 b/g/n
– Wi-Fi Direct (P2P), soft-AP
– Integrated TCP/IP protocol stack
– Integrated TR switch, balun, LNA, power amplifier and matching network
– Integrated PLLs, regulators, DCXO and power management units
– +19.5dBm output power in 802.11b mode
– Power down leakage current of <10uA
– Integrated low power 32-bit CPU could be used as application processor
– SDIO 1.1/2.0, SPI, UART
– STBC, 1×1 MIMO, 2×1 MIMO
– A-MPDU & A-MSDU aggregation & 0.4ms guard interval
– Wake up and transmit packets in < 2ms
– Standby power consumption of < 1.0mW (DTIM3)Paket :
– 1x ESP8266 ESP-01E UPGRADED WIFI WIRELESS TRANSCEIVER MODULE 1MB FLASHSKU: IOT03 - IOT & ESP8266
CH340 NODEMCU V3 LUA WIFI DEVELOPMENT BOARD BASED ON ESP8266
Spesifikasi :
– Uses CH340G instead of CP2102.
– NodeMCU has built-in USB-TTL serial with super reliable industrial strength CH340G for superior stability on all supported platforms.
– Communication interface voltage: 3.3V.
– Antenna type: Built-in PCB antenna is available.
– Wireless 802.11 b/g/n standard
– WiFi at 2.4GHz, support WPA / WPA2 security mode
– Support STA/AP/STA + AP three operating modes
– Built-in TCP/IP protocol stack to support multiple TCP Client connections (5 MAX)
– D0 ~ D8, SD1 ~ SD3: used as GPIO, PWM, IIC, etc., port driver capability 15mA
– AD0: 1 channel ADC
– Power input: 4.5V ~ 9V (10VMAX), USB-powered
– Current: continuous transmission: 70mA (200mA MAX), Standby: 200uA
– Transfer rate: 110-460800bps
– Support UART / GPIO data communication interface
– Remote firmware upgrade (OTA)
– Support Smart Link Smart Networking
– Working temperature: -40 ~ + 125
– Drive Type: Dual high-power H-bridge driver
— Flash size: 4MBytePaket :
– 1x NODEMCU LUA WIFI V3 4MB 32MBITS CH340 FLASH ESP8266 ESP12 NODE MCU BOARDSKU: IOT02 - IOT & ESP8266
NODEMCU ESP8266 CP2102 WIFI IOT LUA
Secara umum :
– Based ESP8266 Serial WiFi SoC dengan onboard USB to TTL menggunakan IC CP2102 (USB to UART Bridge Virtual COM Port)
– Bisa diprogram langsung lewat USB.
– Development Board dengan Open-Source Firmware ini dapat dipergunakan untuk mendevelop aplikasi IoT hanya dengan beberapa baris Lua script.
– Wireless standard : IEEE 802.11b/g/n
– 6 x Digital I/O, 3 x PWM Channels, 1 x ADC Channel
– Full I/O control through WiFi network
– GPIO with 15mA current drive capability
– Supports Smart Link intelligent networking
– Built in 32-bit MCU
– built-in TCP/IP protocol stack, and support multiple TCP Client connection
– UART/GPIO data communication interfaceSKU: n/a
